It may be a big concern for drivers. It is an important thing to know because if you don’t learn how to change a flat tire on the road properly, it could become quite a serious problem. In addition, if you do not know how to change a flat tire properly, it could potentially lead to very expensive damage to your vehicle. Ideally, you should never drive a distance with a lit flat tire.
Therefore, if you must drive a distance with a burnt-out tire, you absolutely should not drive any further than a couple of hundred miles, or you very well may damage your new wheel.
Table of Contents
How much time does it typically take to change a tire?
There are many different answers to this question. Drivers with cars with automatic transmission tend to have a lot less trouble than drivers with manual transmission. This is due to the automatic transmission clutch being in constant contact with the wheel throughout the entire range of motion.
However, drivers who have manual transmission have to make sure that their car is going to move both front and back for them to be able to shift into reverse, thus making learning how to change a flat tire much more difficult.
What do you need of tools?
When learning how to change a flat tire, the most important tools you will need are a wrench, a lug wrench, and a fully inflated spare tire and jack. Without these tools, it is impossible to effectively change a tire.
The first thing you want to do when learning how to change a flat tire is put the jack on your vehicle. Once you have your vehicle on the ground, you can then pull up your vehicle with the jack and the lug wrench.
How to start?
To determine how long it takes to replace a flat, the first thing you want to do is take your hand and make a fist, grip the front of your tire, and slowly extend it outward. Keep doing this until you reach about one-third of the way across your tread. Once you’ve figured out how long it takes, grab the lug wrench and start tightening it down until you feel a secure lock. It may take a few minutes, so be patient.
Once you have your hand completely around your wheel and the lug wrench is snugly in place, pull your vehicle off of the ground and get your foot down on the ground. Next, you want to pull up your car on the side with your break bar facing the street.
Once you can lift your car up, it is time to remove the frame and wheel from underneath your car. To do this properly, you will need to work quickly, since it is likely that the flat tire will pop out of the valve covers.
Let’s move on to the main thing
After you have removed the wheels and body from under your vehicle, it is time to work on the flat itself. Start by unbolting the wheel from the hub and pulling the tire toward the ground. You will then need to unbolt the two arm bolts that are holding the spare tire in place next so that you can easily pull the tire out.
You want to make sure that you place your vehicle on the ground securely so that you don’t have to worry about anything getting damaged as you remove the spare tire.
Next, unbolt the three-point strap that is attaching the hub to the tire. Then, unbolt the wheel from the rest of the hub and put it in a safe location. With your hands, carefully tap the rim to make sure that the hub is resting on concrete. Then, attach the flat tire to the new wheel with the extra bolts that you took out earlier.
You’re close to finishing!
Finally, you will need to secure the jack and your car, so that you can be sure that everything is secure. Place the jack under your vehicle and get the wheel under the car with the extra nuts. Secure the entire rack to your vehicle and take it to the location where you took the flat tire off. Use your manual to lower the jack slowly into the safety jack, and slowly lower yourself into the vehicle.
Leave a Reply